A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 27
Hot-plug SAS or SATA hard drives
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Front bezel
1.
Power down the server (on page 25).
2.
Extend the server from the rack (on page 25).
3.
Remove all hard drives ("Hot-plug SAS or SATA hard drives" on page 27) and hard drive blanks
("Hard drive blanks" on page 26).
4.
Remove the serial label pull tab by extending it out, and then pressing on the underside to release it
from the chassis.
5.
Remove the T-10 Torx screws located on the top of the bezel.