Operating the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-004
6-14
Moving the Robot
3. Open the tape library left front door by using a latch key to unlock both locks (See
Figure 6-2.) Turn the key counterclockwise to unlock the locks, then pull the door
open.
4. Locate the cartridge. See Loading Tapes Into the Tape Library on page 5-18.
5. Insert the cartridge into the tape drive as shown in Figure 6-5.
6. After you insert the cartridge:
•
For the 9840 tape drive:
Wait for one of the following messages to appear on the tape drive’s front panel
and take the appropriate action, if necessary:
°
The Ready F (File Protected) message appears when a write-protected
cartridge loads successfully.
°
The Ready U (File Unprotected) message appears when a cartridge that is not
write-protected loads successfully.
°
The NTReady message appears when the tape in the cartridge has lost
tension. To correct this condition, follow the instructions outlined in the 9840
Tape Drive System user’s Reference Manual.
Figure 6-5. Loading a Cartridge Into the 9840 Tape Drive
