A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 54
4.
Close the heatsink retaining latches.
5. Install the processor air baffle.
6. Install the access panel.
7. Do one of the following:
• Install and lock the bezel.
• Slide the server back into the rack.
8. Power up the server.
PPM
To remove the component:
1. Power down the server (on page 29).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel" on page 30).
• Extend the server from the rack (on page 29).
3. Remove the access panel ("Access panel" on page 31).
4. Remove the processor air baffle ("Processor air baffle" on page 41).