SwitchLinc V2 Dimmer 1000W User’s Guide
Unlinking SwitchLinc Dimmer from an INSTEON Controller
If you are no longer going to control a SwitchLinc Dimmer with an INSTEON Controller, it is very
important that you unlink it, because otherwise the controller will retry any commands intended for the
unused SwitchLinc Dimmer, thus slowing down your system.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Unlinking Mode.
. Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide.
2. Press and hold the Paddle Top for 10 seconds on the SwitchLinc Dimmer that is being
D in its LED
ller, you have
ally.
A. A Second SwitchLinc V2 Dimmer – Follow the instructions in the section
Unlinking a Controlled INSTEON Device from SwitchLinc Dimmer, above.
(Briefly, press and hold the Second SwitchLinc Dimmer’s Paddle Top for 10
seconds twice.)
B. ControLinc™ V2 Tabletop Controller – Press and hold the OFF Button of the
ON/OFF Button Pair you used for controlling SwitchLinc Dimmer for 10 seconds.
To confirm that it is in Unlinking Mode, ControLinc V2’s Status LED will begin
blinking.
C. KeypadLinc™ V2 – Press and hold for 10 seconds the ON Button you used for
controlling SwitchLinc Dimmer, then press and hold the same ON Button for 10
seconds again. To confirm that it is in Unlinking Mode, KeypadLinc V2 will flash
the light that it is wired to once and begin blinking the ON Button that you pushed.
D
controlled. To confirm unlinking, the SwitchLinc Dimmer will blink the top LE
Bar and also the light that it is wired to. Depending on the INSTEON Contro
about 4 minutes to perform this step before Unlinking Mode times out automatic
Page 17 of 36
