A SERVICE OF

logo

Open as PDF
next previous
BRAKES 13-21
Rear Br ake Lever, Pedal and Cables
Brake Pedal Installation
•
Apply grease:
Brake Pedal Pivot [A]
O-ring [B]
•
Install:
Spring [A]
Brake Pedal [B]
•
Apply grease:
O-rings [C]
•
Install:
Brake Cable Joint and Pin [D]
BrakeSwitchSpring[E]
Washers [F]
•
Replace the cotter pins [G] with new ones.
•
Bend both side hooks [H] of switch spring [E] after in-
stalling the spring.
•
Adjust the brake pedal position (see Brake Pedal P osi-
tion).
Brake Cable Removal
•
Remove:
Right Rear Flap (see Frame chapter)
•
Unscrew the adjusters [A] at the rear ends of the cables,
and pull the cables out of the joints [B] and cable mounts.
•
Loosen the knurled locknut [A] at the rear brake lever and
screw in the adjuster [B].
•
Line up the slots [C] i n the brake lever, knurled l ocknut,
and adjuster, and then free the cable from the lever [D].
•
Remove the brake lever cable from the frame.