3-5SectionUsing a Memory Unit (-Vj Versions)
41
The functions of the DIP switches on the memory unit are indicated in the table
below.
• SW1
Switch Function
Automatic transmission
writin
from the memor
OFF: Not executed
SW1-1
unit to the PT)
ON : Executed
Automatic transmission
writin
from the PT to
OFF: Not executed
SW1-2
the memory unit)
ON : Executed
Manual transmission
Direction of transmission
OFF: Not executed
SW1-3
and bank used selected at the PT touch panel)
ON : Executed
OFF: Screen data
SW1-4 Data type to transfer
ON : System
program
• SW2
Switch Function
Disable/enable writing to PT
OFF: Disable
SW2-1 Disable/enable writing to PT
ON : Enable
Disable/enable writing to the memory unit
OFF: Disable
SW2-2 Disable/enable writing to the memory unit
ON : Enable
Area (bank) selection of automatic transmission
*
OFF: Bank 0
SW2-3 Area (bank) selection of automatic transmission. *
ON : Bank 1
System/Screen simultaneous transmission
OFF: Disable
SW2-4 System/Screen simultaneous transmission
ON : Enable
* The memory unit stores system program or screen data for one PT in each of
areas (bank 0, bank 1). (The total data storage is for two PTs.) SW2-3 sets which
of these two banks is used for automatic transmission.
Reference: S The DIP switch function of the memory unit is supplemented to NT31/NT31C
with the Vj suffix.
S In the following cases, a mode setting error occurs.
• More than one of the SW1-1 to SW1-3 switches are set to ON.
• None of the SW1-1 to SW1-3 switches are set to ON.
S In the following case, a protect setting error occurs.
Transmitting to the write destination has been disabled by the setting for
SW2-1 or SW2-2.
S In the following cases, a data transmission error occurs.
• An attempt is made to transmit data other than the system program to PT
system program area.
• An attempt is made to transmit the system program to PT screen data
area.
S For details on mode setting errors and protect setting errors, refer to Errors
When Using a Memory Unit (page 45).
DIP Switch Functions
