![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/b/5f/b5f15891-8338-4414-97aa-0deb8b2836d0/b5f15891-8338-4414-97aa-0deb8b2836d0-bg9.png)
9
(ENG) VQT4U55
ENGLISH
Inserting media
≥ Make sure that the unit does not fall when inserting or
removing media.
≥ When moving this unit, be sure to remove all media and turn
this unit to standby mode.
*1: Refer to “Playable media” for compatible models. (l 5)
*2: When using the “IPOD_PORT” connection, do not connect
the following models to this unit:
– iPod classic, iPod [4th (color display), and 5th (video)
generation], iPod nano (1st generation)
Unexpected behavior may occur.
*3: When using the “IPOD_DOCK” connection:
≥ Be sure to remove the iPod/iPhone from its case.
≥ Make sure that the iPod/iPhone is fully inserted and its
back is resting against the cushion pad.
≥ Make sure to hold the dock when removing the iPod/
iPhone.
*4: Use the “
IPOD_PORT
” connection to charge the iPad.
1 Press [CD <] to open the lid on the back of the CD unit.
≥ Leave a space more than 10 cm (4q) behind the unit.
≥ Do not place any objects behind the unit.
2
While holding the unit, push the center of the CD until it clicks into place, and then close the CD lid.
≥ Be careful not to scratch the CD.
≥ Make sure you place the center of the CD onto the CD spindle of the unit.
Note: Remove the CD only after it stops rotating.
Connect an iPod/iPhone/iPad
*1, 2
∫ Charging an iPod/iPhone/iPad*
4
Charging starts when an iPod*
2
/iPhone/iPad is
connected to this unit.
≥ During standby mode, charging will not start from the USB
cable connection, however it will start as usual from the
Lightning connector.
– To charge from the USB cable connection, start the charging
before turning this unit to standby mode.
≥ Check the iPod/iPhone/iPad to see if the battery is fully
charged. (Once fully recharged, additional recharging will not
occur.)
≥ If this unit is switched to standby mode “IPOD CHARGING” is
shown on the unit’s display.
Connect an iPod/iPhone with
Lightning connector
*
1
Inserting a disc
Select “IPOD_PORT” as the source.
≥ When connecting an iPod/iPhone/iPad, use the dedicated
USB cable (not supplied).
*3
Select “CD” as the source.
Select “IPOD_DOCK” as the source.
10 cm (4q)
The label side
PP_SC-NE5~VQT4U55_eng.book 9 ページ 2013年1月30日 水曜日 午後2時42分