Server
60
Use the following procedure to configure settings to use the proxy server.
1 Click the [Server] button on the setup menu.
2 On the sub-menu that appears, click [Proxy].
This will display the "Proxy setting" window.
3 Configure the settings for each item.
Refer to “Proxy settings” table for details about the settings.
4 Click the [Set] button.
Proxy settings
♦Initial default
Proxy
Item Settings Description
Proxy setup use Off♦ / On Specifies whether a proxy server is used.
• When [On] is selected, configure the [Server address], [Port
number], and [Exceptions] settings.
Server address Address input
(Blank♦)
Enter the name or IP address of the proxy server. When
entering a server name, you must use the DNS.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
Port number Port number input
(80♦)
Enter the proxy server port number.
Exceptions Address input
(Blank♦)
Specifies cameras that do not use the proxy server. Enter the IP
addresses of the exception cameras.
• Enter up to 128 single-byte alphanumeric characters,
including asterisk (*) and period (.).
• When specifying multiple addresses, separate them by
semicolons (;). You can use the "*" special character to
represent any number.
