Error log
57
*1 HDD remove error is an error that occurs when the hard disk drive is removed without pressing the respective USE button.
*2 In the RAID 5 mode or the RAID6 mode, only "Error log" is displayed, but neither "Indication on the LCD" nor "Output from the connector on
the rear panel" is displayed.
*3 "HDD SKIP" is the function that continues recording even when an error occurs, such as an HDD write error, by recording images on the next
HDD.
*4 "Video loss" is an error that may occur between the WJ-NT304, WJ-NT314 and the camera connected to the WJ-NT304.To detect video loss
occurrences using the WJ-ND400, it is necessary to configure the "Panasonic alarm protocol " setting of the WJ-NT304, WJ-NT314, and the
"Site alarm " setting of the WJ-ND400.
Refer to page 58 for information on symbols used on the table above.
Other errors for HTTP
−
<HTTP>OTHER_ERR
−
Network error
output
Move to Config −−CONFIG −
Camera SD memory card
error
CAM cc SD ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Request to start writing on
the camera SD denied
CAM cc SD START ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Request to finish writing on
the camera SD denied
CAM cc SD END ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Request to obtain a data list
on the camera SD denied
CAM cc GET LIST ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Request to obtain SD
memory data on the camera
SD denied
CAM cc GET IMG ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Request to delete SD
memory data on the camera
SD denied
CAM cc DEL IMG ERR
−
NW ERR CAMERA cc SD
ERROR
Camera error
output
Description of error Error log Network log LCD
Output from
connector
