8. IP Access Commands
8-20
August 2002 4200-A2-GB20-00
Error Response:
sid yy-mm-dd hh:mm:ss
M c DENY;
/* RTRV-IPPORT:[tid]:aid_ipport:[ctag][:] */
aid:ERRCDE=errcde
/* error description */
;
Table 8-16. RTRV-IPPORT Response Parameters (1 of 2)
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see Appendix A,
Error Codes
)
aid_ipport As described for command parameters (see Table 8-15, RTRV-IPPORT
Command Parameters), except that ALL is not used
cfg_mode Configuration mode for the IP port. Values are:
MANUAL: Port parameters are configured by the operator
BOOTP: Port parameters are configured using the BOOTP protocol
ipport_nblk Named parameter block for IP Port. The block consists of the following
parameters separated by commas, each followed by an equal sign and
a value.
IPADDR: IP address associated with the port. Address entered by user
if cfg_mode=MANUAL; auto-configured if cfg_mode=BOOTP. The
format is:
– ddd.ddd.ddd.ddd (where ddd is a number 0−255).
NETMASK: IP address network mask. Configured value if
cfg_mode=MANUAL; auto-configured if cfg_mode=BOOTP. The format
is:
– ddd.ddd.ddd.ddd (where ddd is a number 0−255).
PHYADDR: Physical address associated with the port. Must be unique.
The format is:
– xx-xx-xx-xx-xx-xx-xx-xx (where each x is a hexadecimal digit
0−F). This is the MAC address originally assigned to the unit if
aid_ipport=ETH-1.
