Safety Precautions General
– 4 –
• Disconnect all Electronic Control
Module (ECM) connectors (on
electronic engines).
• Do not use the ECM or engine
ground stud for the ground of the
welding probe.
• Ensure that the ground connection
for the welder is as close to the
weld point as possible. This
ensures maximum weld current
and minimum risk to damage of
electrical components on the vehi-
cle.
All Anti–Lock Braking Systems
(ABS)
Before welding anywhere on the vehi-
cle, detach the ABS Electronic Control
Unit (ECU) connector and all other
electronic control units.
Vehicle Load
The load must always be properly
secured so that it cannot move while
the vehicle is in motion, even during an
emergency stop. Side walls, partitions,
headboards, etc., are not designed to
withstand high forces. Loads must not
project more than is permitted by local
or national regulations. The stability of
the vehicle may be impaired by the load
and an increased turning circle may be
required.
Fire Extinguisher
Ensure that you always have a fire
extinguisher with you. It should be well
secured within hand’s reach of the
driver and easily accessible for rescue
workers and others providing assis-
tance. Have the fire extinguisher
checked for operational readiness as
recommended by the manufacturer.
When it has been used, have it refilled
at the earliest opportunity.
First Aid Kit
Make sure that you always have a first
aid kit with you. Replenish the contents
as soon as possible after use.
Winter Driving Conditions
When winter driving conditions are
expected, ensure that your vehicle is
prepared in accordance with the recom-
mendations in “
Preventive Maintenance
Before the Winter Season” on page 88.
When severe winter driving conditions
are anticipated, ensure that your vehi-
cle is fitted with winter tires or that you
have snow equipment, as allowed by
state law.
PB1340A.book Page 4 Friday, September 1, 2000 7:40 AM
