Black plate (22,1)
<YRD5055-A/U>22
Introduction of audio
adjustments
1 Audiodisplay
Shows the audio adjustment status.
2 FIEindicator
Shows when the front image enhancer is
turned on.
3 Loudnessindicator
Appears in the display when loudness is
turned on.
4 BASSindicator
Shows when the bass boost is in effect.
5 SWindicator
Shows when the subwoofer output is turned
on.
6 CUSTOMindicator
Shows when custom equalizer curve is cur-
rently selected.
% Press AUDIO to display the audio func-
tion names.
Press AUDIO repeatedly to switch between
the following audio functions:
FAD (balance adjustment)EQ (equalizer
curve adjustment)LOUD (loudness)
SUB.W (subwoofer on/off setting)80: 0
(subwoofer setting)HPF (high pass filter)
BASS (bass boost)FIE (front image enhan-
cer)SLA (source level adjustment)
# When the subwoofercontroller setting is
P/O:FUL, youcannot switch to SUB.W. (Refer to
page 28.)
# You canselect the 80:0 only when subwoofer
output is turnedon in SUB.W.
# When the rearoutput setting is R-SP:S/W,
you cannnot selectF.I.E. function.
# When selecting theFM tuner as thesource,
you cannot switchto SLA.
# Toreturn to the displayof each source, press
BAND.
Note
If you do notoperate the audio functionwithin
about 30 seconds,the display is automatically re-
turned to thesource display.
Using balance adjustment
You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1 Press AUDIO to select FAD.
Press AUDIO until FAD appears in the display.
# If the balancesetting has been previouslyad-
justed, BAL willbe displayed.
2 Press a or b to adjust front/rear speak-
er balance.
Each press of a or b moves the front/rear
speaker balance towards the front or the rear.
FAD:F15 FAD:R15 is displayed as the front/
rear speaker balance moves from front to rear.
# FAD: 0 is theproper setting when onlytwo
speakers are used.
# When the rearoutput setting is R-SP:S/W,
you cannot adjustfront/rear speaker balance.
Refer to Settingthe rear output and subwoofer
controller on page28.
3 Press c or d to adjust left/right speaker
balance.
When you press c or d, BAL: 0 is displayed.
Each press of c or d moves the left/right
speaker balance towards the left or the right.
Audio Adjustments
En
22
Section
07
