Black plate (27,1)
<YRD5055-A/U>27
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Functiondisplay
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press SOURCE and hold until the clock
appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockFM (FM tuning step)AM (AM tuning
step)R-SP (rear output and subwoofer con-
troller)
Use the following instructions to operate each
particular setting.
# Tocancel initial settings,press BAND.
# You canalso cancel initial settingsby holding
down SOURCE untilthe unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
2 Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.
Turning the clock display on or off
You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
# The clock displaydisappears temporarily
when you perform otheroperations, but the clock
display appears againafter 25 seconds.
Note
Even when thesources are off, theclock display
appears on thedisplay. PressingCLOCK turns
the clock displayon or off.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM.
Press FUNCTION repeatedly until FM appears
in the display.
Initial Settings
En
27
English
Section
08
