A SERVICE OF

logo

PRINTER CONFIGURATION
74
When this item is set to Barber Pole, the printer will print a rotating
character pattern. Printing may be started and stopped with the ONLINE
button.
When set to Hex Dump, the printer will print all received data in a special
debug format, which may be used by programmers to solve software
problems. For more information, refer to the Hex Dump section of the
FormsPro 4000se series Programmer’s Manual.
Note: When in Barber Pole mode and Hex Dump mode, if the printer is
taken OFFLINE during printing, the printer will remain in these modes. If the
printer is put back ONLINE, printing will resume. To exit either of these
modes, return to the TEST MENU and use either VALUE buttons to set
TEST MODE to OFF.