Preparation
● Use Type I (normal) tapes only.
● Set the tape to the point where recording will start.
● Note that recording is done on only one side of the tape.
1
2
3
Insert the tape to be recorded on into Deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit.
,/=
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a taDe, press TAPE. Then, insert the original
tape into Deck 2 and play it.
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press PHONO or
VIDEO/AUX and play.
Press . on Deck 1 to start recording.
b is depressed simultaneously.
When the selected function is CD, playback and recording
start simultaneously.
la
To stop recording, press W= on Deck 1.
To pause recording, press II on Deck 1.
To resume recording, press it again.
To record selected tracks of the CD
Before pressing
● , program the tracks (Page 14).
To record part of the CD
When ● is pressed, recording always starts from the first track.
‘,:’:
To start in the middle of a track, play the CD first and press II SET ‘$.
for CD at the point you wish to start recording from. Then, press
%&
● .The pause mode for CD button is released automatically and ‘~,
recording starts.
&
Q
Sound adjustment during recording
The output volume and tone of the speakers or headphones are @
freely varied without affecting the recording.
,g:,
nEEEl
M
:;;#;
● Do not press the buttons on Deck 2 during recording.
“ . cannot be depressed if the erasure prevention tab on the ~~’
side of the tape to be recorded is broken off.
To erase a recording
A previous recording is erased when a new recording is made
on that part of that tape.
1 Insert the tape you want to erase into Deck 1.
2 Press TAPE and stop all the tape operation in Deck 2.
3 Wind LIDthe ta~e to the ~oint where the erasure isto be started.
4 Press b on beck 1 to ‘start the erasure.
About cassette tapes
● To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
● 120.minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
cTake up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam inthe mechanism.
ENGLISH 15
