A SERVICE OF

logo

13
IDE Connector: IDE
The mainboard has an Ultra DMA 133/100/66 controller. You can
connect up to two IDE devices in any combination.
Pin Signal Pin Signal
1 #IDE_RST 2 GND
3 PD_7 4 PD_8
5 PD_6 6 PD_9
7 PD_5 8 PD_10
9 PD_4 10 PD_11
11 PD_3 12 PD_12
13 PD_2 14 PD_13
15 PD_1 16 PD_14
17 PD_0 18 PD_15
19 GND 20 KEY
21 #PD_REQ 22 GND
23 #PD_IOW 24 GND
25 #PD_IOR 26 GND
27 #PD_RDY 28 PRIMARY_28
29 #PD_ACK 30 GND
31 PD_IRQ14 32 NC
33 PD_A1 34 IDE_DMADET
35 PD_A0 36 PD_A2
37 #PD_CS1 38 #PD_CS3
39 #HD_LED1 40 GND
41 +5V 42 +5V
43 GND 44 #TYPE
If two drives are connected to a single cable, the jumper on the second
drive must be set to slave mode. Refer to the drive documentation
supplied by the vendor for the jumper settings.