Dimension ES-3024 Ethernet Switch
Filter Setup 11-3
Figure 11-2 Configuring or Editing a Mirror Rule
Table 11-2 Configuring or Editing a Mirror Rule
LABEL DESCRIPTION
Active Make sure to select this check box to activate your rule. You may temporarily
deactivate a rule without deleting it by clearing this check box.
Name Type a descriptive name for this mirror rule. This is for identification purposes only.
Direction Choose the direction to which the rule applies from Incoming, Outgoing or Both.
Source The source and destination fields identify the traffic you want to copy for analysis. You
can identify source-destination traffic through a combination of MAC address, VLAN
group and port. Configure these parameters in the next three fields.
MAC Address Type a MAC address in valid MAC address format, that is, six hexadecimal character
pairs or click All Entries to apply the filter rule to all MAC addresses.
VID Type the VLAN group identification number.
Port Select the port to which the filter rule should be applied. You may choose one port only
or all ports (All Ports).
