Chapter 45 Introducing Commands
ES-4124 User’s Guide
348
running-config Displays current operating
configuration.
3
interface port-
channel <port-
list> [bandwidth-
limit...]
Displays current operating
configuration on a port by port
basis. Optionally specifies which
settings are displayed.
3
help Displays the help information for
this command.
3
service-control Displays service control settings. 3
snmp-server Displays SNMP settings. 3
spanning-tree config Displays Spanning Tree Protocol
(STP) settings.
3
ssh Displays general SSH settings. 3
known-hosts Displays known SSH hosts
information.
3
key
<rsa1|rsa|dsa>
Displays internal SSH public and
private key information.
3
session Displays current SSH session(s). 3
subnet-vlan Displays subnet based VLAN
settings on the Switch.
3
system-
information
Displays general system
information.
0
tacacs-server Displays TACACS+ server
settings.
3
tacacs-accounting Displays TACACS+ accounting
server settings.
3
time Displays current system time and
date.
3
timesync Displays time server information. 3
trunk Displays link aggregation
information.
3
version Displays the firmware version
running on the Switch.
0
flash Displays the firmware version on
the flash memory of the Switch.
0
vlan Displays the status of all VLANs. 3
<vlan-id> Displays the status of the
specified VLAN.
3
vlan-stacking Displays VLAN stacking settings. 3
vlan1q gvrp Displays GVRP settings. 3
port-isolation Displays port isolation settings. 3
ssh <1|2>
<[user@]dest-ip>
Connects to an SSH server with
the specified SSH version.
0
Table 140 Command Summary: Enable Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
