Chapter 31 Maintenance
GS2200-24 User’s Guide
276
The following table describes the labels in this screen.
31.2.1 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory
Default to clear all Switch configuration information you configured and return to
the factory defaults.
2 Click OK to reset all Switch configurations to the factory defaults.
Figure 151 Load Factory Default: Start
Table 87 Management > Maintenance
LABEL DESCRIPTION
Current This field displays which configuration (Configuration 1 or Configuration
2) is currently operating on the Switch.
Firmware
Upgrade
Click Click Here to go to the Firmware Upgrade screen.
Restore
Configuratio
n
Click Click Here to go to the Restore Configuration screen.
Backup
Configuratio
n
Click Click Here to go to the Backup Configuration screen.
Load
Factory
Default
Click Click Here to reset the configuration to the factory default settings.
Save
Configuratio
n
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
