Filter
Top Products
APC A/V J Type Power Conditioner and Battery Backup8
Suggested battery replacement date. The Repdate shows the date on which the battery was last
replaced. Update this date if a new battery pack is installed.
Self-test. Select yes to initiate a self-test of the unit. If the test fails, contact APC technical support.
Runtime calibration. Perform a runtime calibration test to completely discharge the batteries, and
recharge them. This allows the unit to accurately predict runtime capacity. This test should be run once a
year, after the unit has been in service for at least one year.
LED and audible alarms test. Perform this test to test the LEDs and the audible alarms on the unit.
Screen saver. Turn the screen saver on or off.
Reset to factory defaults. Reset all settings to the factory default.
REPDATE: 3/04/12
PRESS TO CHNG
DO SELFTEST: NO
PRESS TO CHNG
RUNTIME CAL: NO
PRESS TO CHNG
DSPLY-BP TEST: NO
PRESS TO CHNG
SCREEN SAVER: ON
PRESS TO CHNG
RESET->DEFLT: NO
PRESS TO CHNG