APC J25B Marine Battery User Manual


 
1APC A/V J Type Power Conditioner and Battery Backup
General Information
Overview
The APC
®
by Schneider Electric J Type Power Conditioner protects audio-video systems from power
spikes and surges. The J Type has noise filter banks, which reduce electromagnetic interference to ensure
the best picture and sound quality. The unit also provides clean and safe power to connected equipment in
the event of a power outage.
Inventory
Safety
Electrical Hazard: For indoor use only.
Risk of electric shock. Do not plug into another relocatable power tap.
Overloading. Do not overload the wall outlet where this device is being connected. Do not overload
this device. Ensure the total load to this device does not exceed that which is listed in the Specifications
section of this manual.
Power. Ensure this device is connected to a properly grounded AC power source. Further ensure the
device is plugged into a source providing the required 120 Vac. Do not use a plug adapter which defeats
the ground pin of the AC plug.
Placement. Do not install this device on any unsteady surface. Do not install this device on any heat
source.
Water and Moisture. Do not use this product near any source of water, or in an environment where the
relative humidity may exceed 95% (non-condensing)
Polarization. This device has a polarized AC line plug having one grounding pin. This plug will only
fit into the wall outlet in one orientation. This is a safety feature. Do not remove the round grounding pin.
System Ground Terminal. The unit provides for the connection of grounding wires from all of your
equipment to a central terminal lug. This ground connection eliminates ground loop problems; tie all
component grounds to this screw to break any possible ground loops that can cause an audible noise.
Servicing. There are no user-serviceable components within this device. Removal of the rear cover of
this device may present a shock hazard, and/or void the warranty.
Damage Requiring Service. If any type of damage occurs to this device, immediately disconnect it
from the wall outlet. Notify APC Technical Support or Customer Service at once.
(1) (1) (1)
(1) (1)