Filter
Top Products
General Instructions
Remember to place the program-
ming overlay on the dial pad of
extension 10 before starting.
When you go to another pro-
cedure, start with step 2 of the
instructions for the new pro-
cedure.
You can also exit program mode
by lifting and replacing the
handset, or by replacing it if it
has been lifted.
Programming the PARTNER Plus system requires no complicated steps or
intensive training. By following the detailed instructions given in the rest of this
chapter, you can quickly change system settings. As you become familiar with
programming, use the Programming Quick Reference on the inside back cover
of this guide for procedure codes and settings.
The detailed instructions for each procedure include:
■ A brief description of the procedure
■
Valid data entries or procedure settings
■ Considerations for how the procedure interacts with other procedures (if
appropriate)
■
Programming notes and steps including:
■ Entering system program mode
■ Selecting the procedure
■ Selecting items—
lines, extensions, list, and phone numbers—if necessary
■ Entering data
The instructions use the initial factory setting (designated with an
✔
in the valid
entries section). if your system has been previously programmed, the displays
may differ.
Once you’ve completed the steps in the detailed instructions, the data setting is
saved. You can now
■ go to another procedure,
■ return the data to the factory setting, or
■ exit program mode.
Instructions for these choices are given in the box shown on the bottom of every
two pages:
✔
=
Factory Setting
To go to the next procedure: [
Next Proc ]
To go to a specific procedure: [ # ] [ x ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]
(where XXX is the procedure number)
To return data to the factory setting: [
Remove ]
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-3