Filter
Top Products
Receiving & Installation 2-5
Reverse Operation
Terminal P4–REV is the forward/reverse control. You can reverse
motor direction by connecting P4–REV to P4–COM. Use a jumper wire,
switch, relay, or an open collector NPN transistor.
Caution: Before reversing directions, make sure the motor is
stopped. This control is not designed for plug reversing.
Sometimes it may be necessary to reverse motor direction without using
terminal P4–REV. This is done by stopping the motor and exchanging
terminals P1–Φ1 with P1–Φ2 on the lower board, and terminals P4–S1
with P4–S3 on the upper board.