Filter
Top Products
11
At the location of the elevator wire
make a notch approximately 3/16”
deep and 3/8” wide to clear the ele-
vator wire. At the location of the
tiller arm drill a 3/32” hole and slot
the leading edge of the rudder to
accept the tail wheel wire.
notch for elevator
wire
hole for tail
wheel wire
Slide a piece of masking tape between
the tail wheel wire and the fin post.
Put epoxy glue in the hole and slot on
bottom of rudder where the tail
wheel wire goes in. Install the rud-
der on the CA hinges with the tail
wheel wire in place and pull the
masking tape around to hold the glue
in.
Deflect the rudder fully in one
direction and glue the CA hinges with
two drops of thin CA each. Deflect in
the other direction and glue the
hinges on the other side. When the
epoxy has cured you can remove the
masking tape.
Install the ailerons on the wing and
glue in place by deflecting the
aileron fully in one direction and
apply two drops of thin CA on each
hinge. Turn the wing over and repeat
on the other side.