Filter
Top Products
16
. If you use a mini servo these will not
be used. If you use a standard servo
you will need them to clear the
servo.
Assemble the tank cap with the big
washer, the rubber stopper, and the
little washer in the rear. For a two
line system we will only use the long
piece of aluminum tube and one short
one.
Insert the tubes through the stopper
and attach the silicone tubing on the
short one. Cut the tubing so that
when the clunk is attached it will be
about 1/4” off the bottom of the tank
when held vertically. Leave the tubes
out the front of the cap about 3/4”
and bend the long tube at a 45 degree
angle so it goes to the top of the tank
when installed.
Install stopper in tank and tighten
the bolt in the center until stopper is
snug. Don’t over tighten. Clunk
should move freely and vent tube
should be to the top of the tank.
Mount the tank using the cable ties
through the holes you drilled. Put a
1/2” piece of foam rubber(not sup-
plied) under the tank to prevent foam-
ing. Do not tighten the tank down
tight, let it move around on the foam
or you will get foaming of the fuel.