Filter
Top Products
14
It will be necessary to cut the back
side out of the nylon cover for the
wires to fit in. Using a sharp knife,
cut 1/16” inside the edge of the
cover. Make sure you are cutting the
back side, it fits on the right side of
the plane. The wires can then be fit-
ted inside by staggering the plugs.
location of
hole in wing
Hold the wire cover against the bot-
tom of the wing on the left side with
the other end centered between the
servos and mark the location of the
exit hole into the wing.
Cut a hole next to fuselage large
enough to get the servo plugs
through but not so wide as the cover
will not hide it.
servo lead hole
into wing.
You will need a 12” servo extension
for both rudder and elevator servos.
Fit the wires into the cover, and
leads into the opening in the wing.
Secure the cover in place with the
two metal brackets and four
2.5mmx10mm screws. Drill a 1/16”
pilot hole and harden with thin CA.
Take two four hole control horns
and install on rudder and elevator
servo. The rudder servo arm points up
the elevator arm points down. Use a
pushrod to align rudder horn paral-
lel to servo arm and mount on rudder
using the two 2mmx20mm screws and
nylon plate.