Filter
Top Products
6
BUILDING
INSTRUCTIONS
Before starting to build this kit, we
urge you to read through these
instructions. They contain some
important building sequences as well
as instructions and warnings con-
cerning the assembly and use of the
model.
We expect that you have some build-
ing experience to take on this model.
However, every minute detail is not
covered. This is not a basic trainer.
The instructions together with the
simplicity of this kit will allow you to
produce a first class EX-TREME 330 3-
D.
BUILDING SUPPLIES NEEDED
Hobby knife w/ #11 blade
Thin Zap CA
30 Minute Z-poxy
Thread lock
Wire cutters
Pliers
Drill with bits: 1/8", 5/32", 1/16”
5/64”
Phillips and standard screwdriver
Small clamps
Masking tape
Tape measure
Washable marker
Paper towels
Rubbing alcohol
See the list at the end of the instruc-
tion book for a list of additional R/C
equipment you will need to complete
the EX-TREME 540 3-D.
Test fit the wing in the fuse. Make
any adjustments needed with a sand-
ing block or round file. Try to keep
the fit as tight as possible. Use a
ruler to measure to make sure dis-
tance A - B and C - D are equal. This is
important to make sure the plane
tracks straight and predictably.
AB
D
C
Use a washable marker to mark the
location of the wing in the fuse on
both sides, then remove the wing.
Remove the covering from the wing
joint with a sharp hobby blade, being
careful to only cut the covering and
not the balsa.