Filter
Top Products
Operation
-10- Q-Wash 560Z-LED User Manual Rev. 12
4. Operation
Control Panel
Description
Button
Function
<MENU>
Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected value
in to the current function
<UP>
Navigates upwards through the menu list and increases the numeric value
when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric
value when in a function
Control Options
You can set the Q-Wash 560Z-LED start address in the 001~512 DMX range. This enables
for the control of up to 34 products in the 15-channel ADVANCED personality.
Programming
Refer to the Menu Map to understand the menu options. The menu map has a Menu Level
and a variable number of programming levels for each option.
To go to an option in the Menu Level, press <MENU> repeatedly until the option shows
on the display. Press <ENTER> to select. This will take you to the first programming
level for that option.
To select an option or value within the current programming level, press <UP> or
<DOWN> until the option shows on the display. Press <ENTER> to select. In this
case, if there is another programming level, you will see that first option, or you will see
the selected value.
To exit to the previous menu level, press <MENU>.
In the EDIT menu, <UP> and <DOWN> will only change the value of the current
option. To change to the next option, press <ENTER>.
DMX Operation
1. Select a DMX operation.
a) Go to MENU > INTRO > RUN.
b) Select DMX512.
2. Select a DMX mode.
a) Go to MENU > INTRO > CHANNELS.
b) Select BASIC, ADVANCED, or G1.
3. Select the starting address.
a) Go to MENU > INTRO > ADDRESS.
b) Select a starting address, 001~498 (Advanced), 001~498 (G1) or 001~501 (Basic).
The highest possible starting address for each DMX mode is:
DMX Mode DMX Address
Basic
501
Advanced
498
G1
498
Stand-alone
Operation
1. Go to MENU > INTRO > RUN.
2. Select a stand-alone operation mode (AUTO 1, AUTO 2, CUSTOM, or TEST).
Of all the stand-alone operation modes indicated above, only “CUSTOM” is editable
(see Edit Custom).