Filter
Top Products
8 Installation - Subtended Network 78-5481-02 09/15/98
Cisco 6100 Set Up and Installation Manual8-10
8.3 Adding a DS3 Subtend Card
If you have an existing MC and you need to add a DS3 subtend card, you will need to remove two
of the screws from the backplane, add the standoffs shipped with the card, and reuse the two screws.
See the following figure for an illustration.
Figure 8-9 Adding Standoffs for a DS3 Card
If you are installing the DS3 subtending I/O card on a new (2.2) MC, standoffs for mounting the card
are already in the card cage and the screws to mount the card are included in the package.
DS3 card
Existing
backplane
screw
DS3 card
standoff
DS3 card
standoff
Existing
backplane
screw
16835