Filter
Top Products
78-5481-02 09/15/98 Installation - Subtended Network 8
Cisco 6100 Set Up and Installation Manual 8-11
If you are installing the DS3 subtending I/O card on an older MC, you will need to add the standoffs
to mount the card. The following procedures describe how to add the standoffs. Figure 8-4 illustrates
the procedure.
1 Remove the two screws currently used to hold the backplane to the chassis above and below the
DS3 connector (J48).
2 Install the standoffs included with the DS3 I/O card in the same location as the screws you just
removed.
3 Connect the DS3 I/O card to connector J48 as shown in Figure 8-4.
4 Reuse the screws removed in Step 1 to hold the DS3 I/O card to the backplane.