Filter
Top Products
42
English
43
Nothing Comes Close to a Cobra
®
Mobile Phone Operation
With Bluetooth
®
VHF Marine Radio Protocols
Operating Your RadioVHF Marine Radio Protocols
Mobile Phone Operation
With Bluetooth
®
Operating Your Radio
Connecting a Voice Dial Call
Initiating a Voice Dial Call
To Initiate a Voice Dial Call:
1. Press and release the Bluetooth button to get into
the Bluetooth Standby mode.
2. Press and release the Bluetooth button twice (2x)
from Bluetooth Standby mode. This will initiate the
voice dial feature on the paired mobile phone.
3. You will hear a beep or audio command from the phone.
Press and hold the PTT (Push to Talk) button and
speak the name into the HH475.
4. The mobile phone will begin to dial the contact
it “recognizes.” The call will be complete through
the speaker and microphone of the HH475. You will
see the “diaLng” and “Connct” screens as the call
is completed.
5. Hang up by pressing the Bluetooth button when
you complete your call.
Using Voice Dial
This feature allows you to use your voice to dial a contact from
the contact list on your mobile phone.
NOTE
Voice dialing is an advanced function and may not be
supported by all phones. Cobra suggests you set it up and
become familiar with it on your mobile phone before you
attempt using it in conjunction with the HH475 or another
Bluetooth device.
This is an advanced function and not all mobile phone
combinations will be successful. Some allow you to set
pre-recorded contacts. Some advanced phones have
active voice recognition and match your mobile phone’s
contact list.
To Initiate a Last Number Redial:
1. Press and release the Bluetooth button to get into
the Bluetooth Standby mode.
2. From Bluetooth Standby, press and hold the
Bluetooth button for two (2) seconds [until the
radio beeps two (2) times].
3. The paired mobile phone will redial the last number.
The call will be complete through the speaker and
microphone of the HH475.
4. Hang up by pressing the Bluetooth button when
you complete your call.
Last Number Redial
This feature allows you to redial the last number stored in the
mobile phone’s internal Call Log. This feature is supported by
most mobile phones.
NOTE
If switched to OFF setting, then the HH475 will not
reconnect with mobile phone on power up. It must
be turned back ON again from the Bluetooth
Programming mode.
To End Pairing (At the End of the Day)
You might not want to take your calls through this VHF radio once
you are back at the dock or in a dry location. See the instructions
in the Bluetooth Mode Programming section on page 23 for
instructions on how to Turn OFF the Bluetooth function of the
HH475. The “p” will disappear from the Bluetooth Standby screen.
BluetoothStandby Mode,
Unpaired State
BluetoothStandby Mode,
Paired State
BluetoothButton