Filter
Top Products
EAGLE EVR-100 Operation Instructions14
Turning Your Radio On/Off
Rotate VOL/PWR knob to turn the radio on or off. Rotate to adjust the volume to a comfortable
level.
Adjusting Squelch
Squelch is used to eliminate static and background noise and allows for silent operation of your
radio until a transmission is received. If the squelch is too high, only the strongest transmissions
can be heard, and when too low, intermittent static and noise are heard.
To set Squelch:
1. Turn SQL knob fully counter-clockwise. You will hear a lot of static noise.
2. Then turn SQL knob clockwise slowely until the static noise stops, this is the correct position
for the SQL knob.
Selecting High/Low Power
Press and release the H/L key on the microphone to toggle the transmit power between high and
low. When the unit is operating at low power, “Lo” appears on LCD and “Hi” appears on LCD when
operating at high power.
Some channels allow only low power transmissions. Error beeps will sound if the power
transmission setting is incorrect. Some channels allow only low power transmissions initially, but
can be changed to high power by holding down H/L and PTT at the same time. See Appendix for
a complete listing of channel charts.
Selecting Channels
To select a channel:
Use the + CH - key to find a channel. Stop when you find the desired channel.
NOTE: Not all channel numbers are available in INT bands, see marine Channel charts at the back
of this manual.
Transmitting and Receiving
Press and hold the Push-To-Talk (PTT) key to transmit on the selected channel, then release to
receive. The TX indicator appears while transmitting.
Radio Operation