Filter
Top Products
EAGLE EVR-100 Operation Instructions 9
Connect the Radio Cables
The connectors are on the rear of the base unit, as follows:
1. External Speaker connector. Plug the external speaker cable jack into the connector BEFORE
powering on the radio. Use a 4 Ohm 4 Watt external speaker.
2. RED Power wire. Connect this to the POSITIVE (+) battery terminal. Check that a 3 Amp fuse is
installed on this power cable close to the battery.
3. BLACK Power wire. Connect this to the NEGATIVE (-) battery terminal.
4. ANT. A radio antenna is not supplied. A suitable radio antenna must be mounted and
connected before operating the EVR-100 radio. Consult your dealer for advice if necessary.
5. GND. A ground connection is not usually required.
1
2
3
4
5