Filter
Top Products
73
3. Press → to the first number, then press ↑ to change the number to 1.
4. Press → to the second number, them press ↑ to change the num-
ber to 5 and press
EXIT. The depth indicators now accurately show
the water depth from surface to bottom.
Sensitivity & Auto Sensitivity
The sensitivity controls the ability of the unit to pick up echoes. Sensi-
tivity can be adjusted, because water conditions vary greatly. A low
sensitivity level — from zero to 50 percent — excludes much of the bot-
tom information, fish signals and other target information.
High sensitivity levels let you see this detail, but it can also clutter the
screen with many undesired signals. Typically, the best sensitivity level
shows a good solid bottom signal with Colorline and some surface clutter.
Automatic Sensitivity
The default sensitivity mode is automatic. The unit bases the sensitiv-
ity level on water depth and conditions. When the unit is in the auto-
matic mode, sensitivity is automatically adjusted to keep a solid bottom
signal displayed, plus a little more power. This gives it the capability to
show fish and other detail.
Situations occur when an increase or decrease in sensitivity is needed.
An increase in sensitivity is necessary when you want to see more de-
tail. A decrease in sensitivity will clear up the screen when it becomes
cluttered by tiny air bubbles caused by boat wakes or wave action.
The control bar used to adjust sensitivity up or down is the same
whether the unit is in the automatic or manual mode. In automatic you
can adjust sensitivity up to 100 percent, but the unit will limit your
minimum setting. In auto, the unit will continue to make small ad-
justments, allowing for the setting you selected.
In manual mode, you have complete control over sensitivity with the
ability to set it anywhere from zero to 100 percent. Once you select a
level in manual, the unit will continue to use that exact sensitivity set-
ting until you change it or revert to auto mode.
To adjust sensitivity in auto mode:
1. Press
MENU|ENT.
2. The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity.
Press ↑ to increase sensitivity. When it is set at the desired level, press
EXIT.