Eagle Electronics ID 128 Fish Finder User Manual


 
20
ALARMS
FISH ALARM
The Fish Alarm sounds a tone when a fish
symbol appears on the screen. To use the
fish alarm, press a menu key until the “FISH
ALARM” menu appears on the screen. Now
press the up arrow key to turn the alarm on.
Repeat the above steps to turn the alarm off.
SHALLOW ALARM
The shallow alarm is triggered only by the
bottom signal. No other echo will activate this
alarm. The shallow alarm sounds an alarm
tone when the bottom goes shallower than the alarm’s setting.
To set the shallow alarm, press a menu key repeatedly until the “SHAL
ALARM” menu appears. Press the down arrow key to increase the shallow
alarm's depth setting, the up arrow key decreases it. The number in the
shallow alarm’s menu box shows the current
shallow alarm setting. When the number
reaches the desired setting, release the ar-
row key. When the bottom depth goes shal-
lower than the alarm’s setting an alarm tone
sounds. At the same time the alarm sounds,
a message box appears on the screen as
shown below.
Press the down arrow key to silence the
alarm. This will turn the alarm sound off until
the shallow alarm is triggered again.
To turn the alarm off, press a menu key until
the shallow alarm menu appears. Then press
the up arrow key until the word “OFF” ap-
pears.