Filter
Top Products
5
PERMANENT MOUNT TRANSDUCER INSTALLATION
The HS-WSPC supplied with your sonar is a transom mount transducer.
It can be installed on any outboard or stern-drive (inboard\outboard)
powered boat.
The “kick-up” mounting bracket helps prevent damage if the transducer
strikes an object while the boat is moving. If the transducer does “kick-
up”, the bracket can easily be pushed back in place without tools.
Read the enclosed transducer installation instructions carefully before
attempting the installation. Determine which of the mounting positions is
right for your boat. Use extreme care when mounting the transducer,
since the transducer location is the most critical part of a sonar installa-
tion. If it isn’t done properly, the sonar can’t perform at it’s designed
potential.
Location - General
1. The transducer must be placed in a location that has a smooth flow
of water at all times. If the transducer is not placed in a smooth flow of
water, interference will show on the sonar’s display in the form of ran-
dom lines or dots whenever the boat is moving.
2. The transducer should be installed with it’s face pointing straight
down, if possible.
3. Make certain the transducer's location doesn’t interfere with the
trailer or hauling of the boat. Also, don’t mount it closer than approxi-
mately one foot from the engine’s lower unit. This will prevent cavitation
interference with the propeller. Typically, the transducer should be
mounted as deep in the water as possible. This increases the chance
that it will be in the water in high speed and reduces the possiblity of air
bubble interference.
POOR ANGLEPOOR ANGLE
POOR ANGLEPOOR ANGLE
POOR ANGLE
GOOD LOCATIONGOOD LOCATION
GOOD LOCATIONGOOD LOCATION
GOOD LOCATION
POOR LOCATIONPOOR LOCATION
POOR LOCATIONPOOR LOCATION
POOR LOCATION