Filter
Top Products
OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER EQ1-DYN OPERATION
Daniel Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster Page 8 of 27
) +41 1 940 20 06 2 +41 1 940 22 14 8 http://www.weiss.ch * weiss@weiss.ch
Band Parameters
What Is A Band?
The EQ1 has seven independent bands per chan-
nel. A band has the following parameters which
can be adjusted separately for each band:
1. Mode
2. Boost
3. Q/ Slope / Shape
4. Frequency
Mode specifies the filter type. There are five filter
types (low and high cut, low and high shelving and
peaking) and a bypass mode. Each band has its
own five-LED chain to indicate its active mode
(see
Graph 3).
Graph 3: Mode LEDs
To activate a band and see its detailed parameter
values, touch any knob in a band (see Graph 1,
Œ
). The active band’s parameter values will be
shown in the band display (see Graph 4) replacing
the status display, and its LED chain will light up,
showing you where to adjust the parameter val-
ues.
Graph 4: Band Display
Depending on the setting of “Auto Switch-
back From Band To Status Display”, this
display will hold or disappear again after
having released the knob.
To change the “Auto Switchback From Band To
Status Display” setting, press the “menu” key,
then select “Controls” with key B. The value can
now be changed with key B.
Range
The parameters’ range is independent of the
mode and is listed at page 20.
High Shelving
Low Shelving
Peaking
High Cut
Low Cut