Filter
Top Products
The quality of light and exceptional performance is the result of long research, application of
demanding principles, the long experience of ELINCHROM in lighting products for the studio
and the utilization of the latest technology in this area.
Totally integrated to the range of the ELINCHROM ashes, the Ranger RX units maintain the
traditional look and function that is ELINCHROM.
Ranger RX
The Elinchrom Ranger RX is manufactured by Elinca S.A. CH -1020 Renens/Switzerland
Dear Photographer,
Thank you for buying your Ranger RX autonomous ash unit.
All Elinchrom products are manufactured using the most advanced technology. Carefully
selected component are used to ensure the highest quality and the equipment is submitted to
many controls both during and after manufacture.
We trust that it will give you many years of reliable service.
All ash units are manufactured for the studio and location use of professional photographers.
Only by observance of the information given, can you secure your warranty, prevent possible
damage and increase the life of this equipment.
Note:
This equipement has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules and meets all requirements of the Canadian Interference-Causing Equipement Regulations. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipement
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipement does not cause harmful interferences to radio or television reception,
which can be determined by turning the equipement off and on, the user is encouraged to correct the interferences by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipement and receiver.
- Connect the equipement into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ELINCA S.A. is not responsible for any radio or television interference caused by unauthorised modications of this
equipement or the substitution or attachment of connecting cables and equipement other than those specied by ELINCA S.A.
The correction of interference caused by such unauthorised modication, substitution or attachment will be the responsibility
of the user.
FCC Class B Compliance Statement
Introduction
2