Filter
Top Products
5
Because a portable unit is frequently used "on location" please be aware of the danger, or inconve-
nience, which it may represent to others for example children.
• Before you travel or transport the unit: Select the function "Auto Off" (indicated by the green Led
illuminated) and switch Off the unit.
This will give a maximum of security and no loss of batterry supply until transport.
• If you travel by airplane remove the battery box and the fuse. (page 9)
• Keep ash units out of reach whenever possible.
• Switch off when not in use and disconnect ashheads.
• Cover or otherwise protect in humid conditions.
• If the unit has been exposed to very cold conditions, sudden exposure to warm or humid air may
cause condensation. Flashing a number of times rst will help to internally warm the unit.
• There is high voltage and can be high currents, so please apply all the usual safety precautions
when handling the unit, changing fuses, modelling lamps etc, as you would with mains powered
electronic ash.
• Do not use near ammable/explosive material.
• Do not open the unit. In the event of damage or apparent failure, contact a repair service or any
Elinca agent or email: elinca@elinca.ch
• Always switch off unit before connecting ashheads
• Check always if battery is plugged in correctly
• Check always if ashheads connections are plugged in correctly and locked with the bayonet!
Battery
With a attened battery in place, the Ranger RX may be used with the charger connected. However,
the recycle time between full power ashes will be 50/60 seconds due to limited charging current.
Battery charging will only re-commence when the Ranger RX is switched off.
• The charging time is approximately 3 h to full charge.
• The Battery may be re-charged at any time. “Topping up” will not damage it.
• We suggest a spare Battery Box. Whilst one is in use, the other can recharge.
• To recharge the Battery externally, release the Battery Box, and connect the charger to the battery.
• Before changing the Battery Box, please ensure the Elinchrom Charger is disconnected and
switch off the unit.
• Always switch off the unit before connecting or disconnecting ashheads!
• The head connector must always be locked with the bayonet before any use.
!
Before you start !