Filter
Top Products
DEC 2012 DANIEL MODEL 788DVC DIGITAL CONTROL VALVES
TM
INSTALLATION AND MAINTENANCE4-2
EQUIPMENT DAMAGE
It is recommended that the external pump control be turned to the OFF position when
performing any electrical wiring installation and until initial control valve adjustments
are made in the DL8000.
Failure to comply with these procedures could result in damage to the equipment and
compromise in the integrity of the operation.
5. Flush the line of any and all contaminates.
6. Bleed as much air as possible from the system before start up.
4.2 General Considerations as Applied to the DL8000
Upon completion of the preliminary installation of the Digital Control Valve a Start-up
Adjustment Procedure must be administered. Reference “DL8000 Preset Controller Instruction
Manual”, P/N D301244X012.