Filter
Top Products
2
CbN Series 2000
Gearmotors and Reducers
Safety First
High voltage and rotating parts can cause serious or fatal injury. Safe installation, operation and maintenance must be
performed by qualified personnel. Familiarization with and adherence to NEMA MG2, the National Electric Code and local
codes is recommended. It is important to observe safety precautions to protect personnel from possible injury. Personnel
should be instructed to:
1. Avoid contact with energized circuits or rotating parts.
2. Disconnect all power sources before initiating any maintenance or repair.
3. Act with care in accordance with prescribed procedures in handling and lifting
this equipment.
4. Be sure unit is electrically grounded in accordance with code requirements.
5. Be sure equipment is properly enclosed to prevent access by children or other
unauthorized personnel in order to prevent possible accidents.
6. Be sure shaft key is fully captive before unit is energized.
7. Avoid contact with capacitors until safe discharge procedures have been
completed.
8. Most units are shipped with oil. Always be sure oil lubricated units are filled with
correct oil to proper level before operating.
9. Provide proper safeguards for personnel against rotating parts and applications
involving high inertia loads which can cause overspeed.
10. Avoid extended exposure to equipment with high noise levels.
11. Be familiar with the equipment and read all instructions thoroughly before
installing or working on equipment.
Thank you for choosing CbN gearing products. Each CbN Series 2000 gearmotor or reducer is a high quality drive unit
manufactured with the most modern materials, and is thoroughly tested prior to shipment. To ensure you obtain optimum
life from the unit, read and follow these instructions.