Emerson 8610E Scuba Diving Equipment User Manual


  Open as PDF
of 20
 
3
CbN Series 2000
Gearmotors and Reducers
Installation Instructions
Start-Up
Before operating the reducer or gearmotor, the following must be done:
• Installthedriveonarigidandvibration-freesurface.
• Removetheprotectivecoatingontheshaftandange.Usesolventifnecessary.
• Carefullyinstallcoupling,sheaves,sprockets,orpinionsonshaft.Mountasclosetotheshaftshoulderas
possible.
• Itispreferabletouseheatinsteadofforce.Do not hammer on shaft!
• Checkshaftalignmentwhenusingdirectcoupling.
• Checkshaftparallellismwhenusingbeltorchaindrive.
CAUTION: Refertobeltmanufacturer’srecommendationforbelttension.
(Tension should not be applied on chain drives.)
• Checkoillevelinoillubricatedreducer.
• Installbreatherplugintheplugholeperrecommendationsshownonpage(8).Remove pin from center of
breather plug if breather design is per diagram below.
Maintenance
To ensure safe operation and to avoid problems, it is recommended the reducer or gearmotor be inspected every 50
hours of operating time.
• Checkmountingboltsandbelttension(ifapplicable).
The preventative maintenance list below should be performed every 5000 hours of operating time:
• Checkoillevelandaddoilifnecessary.
• Makesuretheventholeinthebreatherisclean.
• Reducerbreathersnotsuppliedwithcross-pindonotgetmodiedbutmustbeproperlypositionedatthetop
of the reducer.
• Formotor/couplingmountingofreducerswithonepiecesplinedcoupling,refertoinstructionincludedinthis
manual on page (4).
PIN
 previous next