Filter
Top Products
31
Part VI: Installation / Wiring Diagrams
INSTALLATION
Your Faria Antares unit can be mounted to your instrument panel in 4 ways; Panel
Mount, Flush Mount, Gauge Mount, and Gimble Mount
Panel Mount
Step 1: Cut a square hole with rounded corners to match the dimensions as indicated in
the figure below.
Step 2: Insert the Antares unit from front of panel, placing the Panel Mount Gasket
(GK0206) between the Antares and the panel.
Step 3: From back of panel, install back clamp. The four interior studs should line up
with the four interior holes of the back clamp. Tighten the supplied nuts, washers, and
lock washers to 7-10 inch pounds (slightly more than finger tight)
Step 4: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares
unit. Proper connection requires the locking ring on each harness to be rotated about ¼
turn.
Step 5: Connect available inputs to corresponding wire harnesses. See pages 34-37 for
detailed wiring information