Filter
Top Products
7
*For sender connection information, refer to wiring diagram HN0605 in Part VI (pg. 36)
for further information.
TANK 1 – Select the type of level sender connected to Pin 5 on HN0605*.
If nothing is connected, select “NONE”.
TANK 2 – Select the type of level sender connected to Pin 6 on HN0605*.
If nothing is connected, select “NONE”.
TRIM / TANK 3 – Choose the type of analog trim sender or level sender
connected to Pin 7 on HN0605*. If nothing is connected, select “NONE”.
AIR TEMP – Select “INSTALLED” if an analog Air Temp sender is
connected to Pin 9 on HN0605*. If an air temp sender is not connected,
select “NOT INSTALLED”
SPEED SOURCE – Choose the type of speed signal to be used by the
Antares. Refer to your boats owner’s manual to determine which type of
speed options are installed on your boat and are connected to your
Antares.
DIGITAL PWS – A digital paddlewheel sender is connected
via the J1939 backbone.
GPS – A NMEA0183 GPS signal is connected. *
ANALOG PWS – An analog paddlewheel sender is connected to pin 9
on HN0605. *
NONE – No speed signal is connected.
Once you have saved all the appropriate settings, press to return to the SYSTEM
SETUP menu.