Filter
Top Products
33
Gauge Mount
Step 1: Cut a 3 3/8” round hole in your boat’s console
Step 2: Insert the Antares through the hole, placing the Gauge mount gasket (GK1234)
between the Antares unit and the panel.
Step 3: From back of panel, install back clamp. The two interior studs should line up
with the two holes of the back clamp. Tighten the supplied nuts, washers, and lock
washers to 7-10 inch pounds (slightly more than finger tight)
Step 4: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares
unit. Proper connection requires the locking ring on each harness to be rotated about ¼
turn.
Step 5: Connect available inputs to corresponding wire harnesses. See pages 34-37 for
detailed wiring information