Filter
Top Products
14
Turning the waypoint mark on/off
The destination waypoint set on a navigator
may be shown on the radar display. It is shown
by a dashed ring which is connected to the
screen center by a dashed line. (See Figure
2-23.) You can turn this mark on and off
alternately by pressing the [FTC] and [SHIFT]
keys together.
2.25 Displaying Navigation
Data During Stand-by
Navigation data may be displayed during
stand-by (requires external sensors) as follows:
1. Press the [MENU] key to open the menu.
2. Select DSPL ON STBY.
3. Select NAV.
4. Press the [MENU] key to register your
selection and close the menu.
WP
215.5°M
12.5NM
CSE SPD
210.5° 12KT
34°42.25' N
135°24.12' E
36378.1
59096.4
TEMP
18.5°C
DEPTH
1 2 5 M
LL
TD
Figure 2-24 Sample navigation data
screen shown during stand-by
Note: Nav data can be accepted from two
sources: navigator and video sounder. When
two of the same type of device is outputting
data to the radar and the data is not identical,
the two sets of data are displayed alternately.
Unit of measurement for depth and
water temperature
The unit of measurement for depth and water
temperature (external sensors required) can be
selected with the [EBL] key in the sequence of
Meters/Centigrade, Feet/Fahrenheit,
Fathoms/Centigrade.
Note: The unit of depth measurement available
depends on the data sentence output by
external equipment as below.
DBT(Ver.1.5) Meters, feet and fathoms
DPT(Ver.2.0) Meters only
2.26 Echoes in Black or White
The default setting displays echoes in shades
of black on a white background. However, you
may reverse this arrangement as shown below
to suit lighting conditions. Note that the default
setting is restored whenever the power is
turned off.
1. Press the [MENU] key to open the menu.
2. Select VIDEO.
3. Select RVS.
4. Press the [MENU] key to register your
selection and close the menu.
2.27 Selecting Ranges to Use
This radar has 14 ranges, some you may not
require. You can select the ranges to use as
follows:
1. Press the [MENU] key to open the menu.
2. Select RANGE.
3. Select (highlight) range to use and press the
[EBL] key. Ranges in use are highlighted.
4. Press the [MENU] key to register you
selection and close the menu.
Note: At least two ranges are left on
(highlighted).