Filter
Top Products
15
Cable connection at transponder
Fabrication of cables TTYCS-4 and TTYCS-1Q
L
6
Removepaint
by50mm.
Vinyltape
Shield
45
50
Cutvinylsheath.
Exposecoreandfoldback
shieldontocable.
Layinclamp
wherepaint
wasremoved.
L: Depends on equipment connected.
Measure at the transponder.
Connection
Procedures
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
Terminal opener
Wiring for WAGO connector
WAGO connector
Wire
Twist
Press downward.