Furuno FA-150 Marine RADAR User Manual


 
i
WARNING
Turn off the power at the switch-
board before beginning the
installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water
splash.
Water in the equipment can result in
fire, electrical shock or damage the
equipment.
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Connection of an incorrect power
supply can cause fire or damage the
equipment. The voltage rating of the
equipment appears on the label above
the power connector.
ELECTRICAL SHOCK HAZARD
Do not open the equipment unless
totally familiar with electrical
circuits and service manual.
Only qualified personnel should work
inside the equipment.
CAUTION
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
Steering
compass
FA-1501
FA-1502
GVA-100
0.3 m 0.3 m
DB-1
0.3 m 0.3 m
PR-240
0.9m 0.6 m
Attach securely protective earth to the
ship's body.
The protective earth is required to the
power supply to prevent electrical shock.
UAIS Transponder
Monitor unit
1.2 m 0.8 m
0.45 m 0.3 m
Mandatory Action
Prohibitive Action
WARNING
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
Warning, Caution
SAFETY INSTRUCTIONS
The installer must read the safety instructions before attempting to install this equipment.