Filter
Top Products
6. CHART OVERVIEW
6-31
Check position sensors ([POSN] page)
Open the menu and click the [POSN] tab in the [System Sensor Settings] page or [Lo-
cal Sensor Settings] page of the [Sensor] menu. The [Prim] and [Second] labels indi-
cate the type of the position sensor. (In the figure below the [Prim] label shows GPS1.)
[Prim] and [Second] indicate sensor status and priority.
Only one sensor can be primary while the others can be secondary or off position. Af-
ter a sensor is turned off, its status is changed to Secondary state. When a position
sensor state is changed to primary and another sensor was primary, the sensor for-
merly primary becomes secondary.
Select the "Primary" navigation sensor as the sensor that is considered to be most ac-
curate and reliable. Set all other navigation sensors as "Secondary".
6.16.5 How to reset odometer and trip meter
To reset the odometer and/or trip meter do as follows:
1. Open the menu and select the [Voyage] menu from the [NAVI Log] menu in the
[Record] menu.
2. Click one of the following buttons.
[Reset All]: Reset both the odometer and the trip meter.
[Reset Trip]: Reset the trip distance.
3. Click the [Close] button to finish.
Passed
LAT:
LON:
Not Available
LAT:
LON:
Second shows Integrity as
“Not Available” when only one
position-fixing equipment is
connected.