Furuno GP-1650F Marine GPS System User Manual


 
1-16
Through-hull mount water temperature/speed
sensor ST-02MSB, ST-02PSB
Select a suitable mounting location considering the following:
Select a mid-boat flat position. The sensor does not have to be
installed perfectly perpendicular. The sensor must not be damaged
in dry-docking operation.
Select a place apart from equipment generating heat.
Select a place in the forward direction viewing from the drain hole,
to allow for circulation of cooling water.
Select a place free from vibration.
1. Dry-dock the boat.
2. Make a hole of approx. 51 mm diameter.
3. Unfasten locknut and remove the sensor section.
4. Apply high-grade sealant to the flange of the sensor.
5. Pass the sensor casing through the hole.
6. Face the notch on the sensor toward boat’s bow and tighten the
flange.
7. Set the sensor section to the sensor casing and tighten the lock-
nut.
8. Launch the boat and check for water leakage around the sensor.
Locknut
Flange nut
Coat with
silicone sealant.
Brim
Face "notch"
toward bow.
51
123
ø77
Figure 1-22 Water temperature/speed sensor ST-02MSB,
ST-02PSB